VUOTOTECNICA VTL10/FG

These vacuum pumps have a suction flow rate of 10, 15 and 20 m3/h. The vacuum lubrication with oil recirculation is adjusted via two oilers located in correspondence of the support bearings. The rotor is cantilevered-fitted on the motor shaft and supported by independent bearings housed in the two pump flanges. The pump and the electric motor are, therefore, two independent units and fixed onto a special support and connected to each other via an elastic transmission joint. All this allows using standard electric motors, in the shapes and sizes indicated in the table. The pump is surface cooled. Heat is dispersed from the outer surface, suitably finned, by means of a radial fan placed between motor and pump. An oil recovery tank is installed on the pump exhaust. This tank contains a separator filter that prevents oil mists and reduces noise. We strongly recommend installing a check valve and a filter on the suction inlet. Also this range of pumps can be supplied with single-phase electric motors.